I made the files for Matts faceplates, all ready to print and cast, same process as before so it went a bit quicker.
All decimated and ready to 3d print.
The 3D prints printed fine except the edges were very messy, so messy in fact i had to sand them and re shape them with car body filler, that worked a treat this will make the silicon moulds easier.
I silicon moulded them all, and made sure to make them a little different than before. sadly its not actually much better, putting the spout on the seam caused issues and made moulds split when i wanted to keep them tight. i had to wrap them in cling film to resolve the issue.